Minco: All-Polyimide Thermofoil Heaters
All-Polyimide heaters from Minco combine Kapton® insulation with polyimide adhesive to achieve a temperature rating of 260°C (500°F) - 60°C higher than previously possible with Kapton heaters and 25°C higher than silicone rubber heaters. The new construction, called "AP", allows 100% more power - 100 watts per square inch (15.5 watts per square centimeter) - for faster warm-up and rapid response to changing heat loads. The result is higher throughput in many thermal processes.
AP heaters are suitable for vacuum use with outgassing less than 0.01% collected volatile condensable material. They stand up to most processing and cleaning chemicals, making them an excellent choice for ultra-pure processes. Applications include semiconductor processing and test, avionics, packaging equipment, and graphics processors. Heaters may be clamped to heat sinks or factory bonded with polyimide adhesives for complete thermal subassemblies.
Options include integral temperature sensors and flex circuit
interconnects. Heat patterns can be uniform or custom profiled for the
specific application. Profiling adds extra heat at loss points to improve
the uniformity of the temperature across the heater. See more info
at: Minco AP
Heaters
All Sensors: Dual Element Pressure Sensor
The All Sensors BDS Basic Pressure Sensor was designed with the idea of combining two sensing elements into one package. This sensor is designed to provide a precise flow measurement by combining a differential and absolute sensing element in the same package, which can save cost and space in today’s smaller devices.
The
BASIC series pressure sensors are based upon a proprietary technology to
reduce the size of the sensor and yet maintain a high level of
performance. Output offset errors due to position sensitivity and
packaging stress and long term drift are all significantly reduced
compared to conventional silicon sensors. See more info at:
All Sensors BDS
Selco: Probe Thermostats
Selco’s probe thermostats offer virtually unlimited custom housings and harness options to meet unique application requirements. These thermostats feature preset temperatures from 41ºF to 500ºF with reset temperatures from 3ºF to 50ºF, depending on the application requirement. Probe housings are constructed in one-piece stainless steel or brass to provide a permanent seal for immersible applications. All thermostats are over-molded with epoxy selected and rated specifically for your application.
With
over 15 off-the-shelf probe mounting configurations to choose from,
selecting just the right assembly is easy. Various voltage and amperage
ratings are available. Customized options are also available.
Terminations can be a simple lead wire or custom connector. See more
info at:
Selco Probe Thermostats
Sherborne Sensors: Servo Inclinometer
The Sherborne Sensors LSI Series is a cost effective precision gravity referenced servo inclinometer that can be used for a wide variety of industrial and military applications. Models are available with a choice of ranges with low impedance output signal. The high-level 5-Volt DC output signal is proportional to the sine of the measured angle of tilt. The fully self-contained IP64 sensor is powered by DC voltage. Electrical terminations are via solder posts.
The
LSI Series is designed to withstand severe shock and vibration for
demanding environments. Typical applications include level control
for machines and structures. They are ideal for crane safety and
satellite antenna leveling applications. The units carry a
comprehensive two-year warranty and they are part of the Sherborne Sensors
Guaranteed On-Time Delivery program. See more info at:
Sherborne Sensors LSI